INSTALLATION
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
- CAUTION:
- Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).
| 1. INSTALL SEAT POSITION AIRBAG SENSOR |
Using a 1 mm (0.039 in.) feeler gauge, install the seat position sensor.
- NOTICE:
- If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
- When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
- If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
- HINT:
- Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm to 1.4 mm (0.023 to 0.055 in.).
Using a T30 "torx" socket, tighten the "torx" screw to install the seat position sensor.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm to 1.4 mm (0.023 to 0.055 in.).
Connect the connector.
Install the seat slide position sensor protector to the seat position sensor.

| 2. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat) |
Remove the 2 bolts on the rear side of the seat.

Lift up the seat track adjusting handle and move the seat to the rearmost position.
Remove the 2 bolts on the front side of the seat.

Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.
Disconnect the connector under the seat.
Remove the seat.
- NOTICE:
- Be careful not to damage the vehicle body.
| 3. INSTALL FRONT SEAT ASSEMBLY (for Power Seat) |
Check the power seat operation.
w/ Seat Heater System:
Check the seat heater operation.Turn the ignition switch on (IG).
Push the seat heater switch ON.
Wait 5 minutes or more and confirm that the seat surface becomes warm.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).
