REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
- CAUTION:
- Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat) |
Remove the 2 bolts on the rear side of the seat.

Lift up the seat track adjusting handle and move the seat to the rearmost position.
Remove the 2 bolts on the front side of the seat.

Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.
Disconnect the connector under the seat.
Remove the seat.
- NOTICE:
- Be careful not to damage the vehicle body.
| 3. REMOVE FRONT SEAT ASSEMBLY (for Power Seat) |
Operate the power seat switch knob and move the seat to the foremost position.
Using a screwdriver, detach the 2 claws.

- HINT:
- Tape the screwdriver tip before use.
Remove the front seat track bracket outer cover in the direction indicated by the arrow in the illustration.
Using a screwdriver, detach the 2 claws.

- HINT:
- Tape the screwdriver tip before use.
Remove the front seat track bracket inner cover in the direction indicated by the arrow in the illustration.
Remove the 2 bolts on the rear side of the seat.

Operate the power seat switch knob and move the seat to the rearmost position.

Remove the 2 bolts on the front side of the seat.
Operate the power seat switch knob and move the seat to the center position. Then, operate the power seat switch knob and move the seatback to the upright position.
Disconnect the cable from the negative (-) battery terminal.
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Disconnect the connectors under the seat.
Remove the seat.
- NOTICE:
- Be careful not to damage the vehicle body.
| 4. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR |
| 5. REMOVE SEAT POSITION AIRBAG SENSOR |
Remove the seat slide position sensor protector from the seat position sensor.

Using a T30 "torx" socket, remove the "torx" screw and seat position sensor.
Disconnect the connector.
