Source Voltage Drop
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
The SRS is equipped with a voltage-increase circuit (DC-DC converter) in the center airbag sensor in case the source voltage drops.When the source voltage drops, the voltage-increase circuit (DC-DC converter) functions to increase the voltage of the SRS to a normal working level.
A malfunction in this circuit is displayed differently from other codes, in the fact that no DTCs are recorded. With a normal system code present, the source voltage drop is indicated when the SRS warning light comes on.
A malfunction in this circuit is not recorded in the center airbag sensor.
The SRS warning light automatically goes off when the source voltage returns to normal.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WIRE HARNESS (CENTER AIRBAG SENSOR ASSEMBLY - BATTERY) |
![]() ![]() |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Disconnect the E49 connector from the center airbag sensor.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch on (IG).
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Specified Condition
E49-21 (IG2) - Body ground
11 to 14 V
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (CENTER AIRBAG SENSOR ASSEMBLY - BODY GROUND) |
![]() ![]() |
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
E49-25 (E1) - Body ground
Below 1 Ω
E49-26 (E2) - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK SRS WARNING LIGHT |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Connect the E49 center airbag sensor connector.
Connect the cable to the negative (-) battery terminal cable, and wait for at least 2 seconds.
Turn the ignition switch on (IG), and wait for at least 6 seconds.
Operate all components of the electrical system (defogger, wiper, headlight, heater, blower, etc.) and check that the SRS warning light does not come on.
- OK:
- SRS warning light does not come on.
|
|
||||
| OK | ||
| ||


