2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2007

HINT:
The type of ignition switch on this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the "EXPRESSIONS OF IGNITION SWITCH" precaution (Click here).


CHECK DIFFERENTIAL PRESSURE SENSOR

  1. B127990E01
    Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the Intelligent tester main switch ON.

  1. Select the menu items: Powertrain / Engine / Data List / DPNR Differential Pressure.

  1. Using pliers, grip the claws of the clip and slide the clip to disconnect the No. 1 vacuum transmitting hose from the sensor.

  1. A129333E02
    Using SST, apply pressure to the sensor.
    SST
    09992-00242  

  1. Check the pressure value of the sensor.

    Standard pressure:
    Approximately the same pressure as the applied pressure is indicated.

    NOTICE:
    Perform the inspection within the range of 0 kPa to 98 kPa (0 kg/cm2 to 1 kg/cm2).

    If the result is not as specified, check the sensor circuit (Click here).

  1. Using pliers, grip the claws of the clip and slide the clip to connect the No. 1 vacuum transmitting hose.

← COMPONENTS (from Jan 2007)REMOVAL (from Jan 2007) →