2005-2008 RAV4 · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedures listed below are for the LH side.


1. REMOVE REAR DISC BRAKE PAD
  1. Remove the 2 disc brake pads.


2. REMOVE ANTI-SQUEAL SHIM
  1. Remove the shims from each pad.


3. REMOVE PAD WEAR INDICATOR PLATE
  1. Remove the indicator plates from the pads.


4. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE
  1. Remove the 2 plates from the brake cylinder mounting.


5. REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH

  1. C127287
    Remove the 2 bolts and cylinder mounting.


6. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN

  1. C127298
    Remove the 2 pins (upper and lower) from the mounting.


7. REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSH

  1. C127071E02
    Using a screwdriver, remove the slide bush from the slide pin (lower).

    NOTICE:
    Be careful not to damage the pin.

    HINT:
    Tape the screwdriver tip before use.


8. REMOVE REAR DISC BRAKE BUSH DUST BOOT

  1. C127299
    Remove the 2 boots from the mounting.


9. REMOVE CYLINDER BOOT

  1. C127288E01
    Using a screwdriver, pry out the set ring and boot.

    NOTICE:
    Be careful not to damage the brake piston and cylinder.

    HINT:
    Tap the screwdriver tip before use.


10. REMOVE REAR DISC BRAKE PISTON

  1. G033449E02
    Place a piece of cloth between the piston and disc brake cylinder.

  1. Apply compressed air to remove the piston from the disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when applying compressed air.

    NOTICE:
    Be careful not to spatter the brake fluid.


11. REMOVE PISTON SEAL

  1. C127290E01
    Using a screwdriver, pry out the seal from the cylinder.

    NOTICE:
    Be careful not to damage the inner cylinder and piston seal groove.

    HINT:
    Tap the screwdriver tip before use.


12. REMOVE REAR DISC BRAKE BLEEDER PLUG
  1. Remove the bleeder plug cap and bleeder plug from the cylinder.


13. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
  1. Remove the shoe adjusting hole plug from the rear disc.


14. REMOVE REAR DISC

  1. C129072E01
    Put matchmarks on the disc and axle hub.

  1. Release the parking brake.

  1. C127304
    Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  1. Install the shoe adjusting hole plug to the rear disc.

← REMOVAL (from Aug 2007)INSPECTION (Nov 2005 – Jul 2007) →