DATA LIST / ACTIVE TEST
System information · Vehicles built from Aug 2007
Versions by build date: Nov 2005 – Jul 2007 from Aug 2007
| READ DATA LIST |
![]() ![]() |
- HINT:
- Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester ON.
Read the Data List by following the prompts on the tester screen.
Air conditioning amplifier Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Ambient Temp Sensor
Ambient temperature sensor /
Min.: -23.3°C (-9.94°F)
Max.: 65.95°C (150.71°F)
Actual ambient temperature is displayed
Open circuit: -23.3°C (-9.94°F)
Short circuit: 65.95°C (150.71°F)
Engine Coolant Temp
Engine coolant temperature /
Min.: 1.3°C (34.34°F)
Max.: 90.55°C (194.99°F)
Actual engine coolant temperature is displayed after engine warmed up
-
Adjusted Ambient Temp
Adjusted ambient temperature /
Min.: -30.8°C (-23.44°F)
Max.: 50.8°C (123.44°F)
-
-
Evaporator Fin Thermistor
Evaporator temperature sensor /
Min.: -29.7°C (-21.46°F)
Max.: 59.55°C (139.19°F)
Actual evaporator temperature is displayed
Open circuit: -29.7°C (-21.46°F)
Short circuit: 59.55°C (139.19°F)
Regulator Pressure Sensor
Regulator pressure sensor /
Min.: -0.45668 MPaG
Max.: 3.29437 MPaG
Actual regulator pressure is displayed
-
Regulator Control Current
Regulator control current /
Min.: 0 A
Max.: 0.997 A
Value changes between 0 A and 0.997 A in accordance with compressor operation
-
Electric Heater Count
Electric (PTC) heater count/
Min.: 0
Max.: 3
Actual number of the heater elements to be heated is displayed
-
Number of Trouble Codes
Number of trouble codes /
Min.: 0, Max.: 255
Number of DTCs displayed
-
| PERFORM ACTIVE TEST |
- HINT:
- Performing the intelligent tester's Active Test allows relays, the VSV, actuators and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed in the Active Test.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester ON.
Perform the Active Test according to the display on the tester.
Air conditioning amplifier Tester Display
Test Part
Control Range
Diagnostic Note
Magnetic Clutch Relay
Magnetic clutch relay
OFF, ON
-
Electric Heater 1
PTC heater No. 1 relay
OFF, ON
-
Electric Heater 2
PTC heater No. 2 relay
OFF, ON
-

