REMOVAL
Removal / installation · Vehicles built from Nov 2005
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Use the same procedures for the RH side and LH side.
| 1. REMOVE ROOF DRIP SIDE FINISH MOULDING LH |
![]() ![]() |
Remove the 2 roof drip moulding joint covers from the vehicle body.
Remove the No. 2 center roof drip side finish moulding and roof drip side finish moulding.
- NOTICE:
- Do not remove the clips from the vehicle body.
- If the clips are damaged or removed accidentally, replace them.
- Do not remove the clips from the vehicle body.


