2005-2008 RAV4 · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Aug 2007


1. INSTALL 2ND BRAKE PISTON O-RING

  1. D026706E02
    Coat 2 new O-rings with ATF, and install them in the 2nd brake piston.

    NOTICE:
    Make sure that the O-rings are not twisted or pinched.


2. INSTALL 2ND BRAKE PISTON

  1. D026775E01
    Coat the 2nd brake piston with ATF, and install it to the 2nd brake cylinder.

    NOTICE:
    Be careful not to damage the O-rings.


3. INSTALL 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY

  1. D026704E04
    Install the 2nd brake piston return spring.

    NOTICE:
    After installing the spring, check that all of the springs fit in the piston correctly.

  1. D026703E02
    Place SST on the piston return spring, and compress the piston return spring with a press.
    SST
    09387-00060  

  1. Using a screwdriver, install the snap ring.

  1. Make sure that the end gap of the snap ring is not aligned with the spring retainer claw.

    NOTICE:
    Stop the press when the spring seat is lowered to a position 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove. This prevents the spring seat from being deformed.

← INSPECTION (from Aug 2007)COMPONENTS (from Aug 2007) →