2005-2008 RAV4 · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Aug 2007


INSPECT PACK CLEARANCE OF REVERSE CLUTCH

  1. D026426E02
    Install the intermediate shaft and needle roller bearing onto the rear transaxle cover.

  1. Using a dial indicator, measure the reverse clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Standard pack clearance:
    0.60 to 0.82 mm (0.0236 to 0.0323 in.)

    If the pack clearance is not as specified, inspect the discs, plates and flange.


INSPECT PACK CLEARANCE OF DIRECT CLUTCH AND OVERDRIVE CLUTCH

  1. D026427E01
    Using a dial indicator, measure the direct clutch and overdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Standard pack clearance:
    0.61 to 0.83 mm (0.0240 to 0.0327 in.)

    If the pack clearance is not as specified, inspect the discs, plates and flange.


INSPECT DIRECT MULTIPLE DISC CLUTCH DISC

  1. D026718E01
    Check if the sliding surfaces of the discs, plates and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of a disc comes off or is discolored, or if a part of the groove is worn, replace all the discs.
    2. Before installing new discs, immerse them in ATF for at least 15 minutes.


INSPECT OVERDRIVE DIRECT CLUTCH DISC

  1. D026719E01
    Check if the sliding surfaces of the discs, plates and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of a disc comes off or is discolored, or if a part of the groove is worn, replace all the discs.
    2. Before installing new discs, immerse them in ATF for at least 15 minutes.


INSPECT OVERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D009211E03
    Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    25.91 mm (1.0201 in.)

← DISASSEMBLY (from Aug 2007)REASSEMBLY (from Aug 2007) →