2005-2008 RAV4 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE STEERING PAD ASSEMBLY

B130245E01
  1. Straighten the front wheels.

  1. Using a T30 "torx" driver, loosen the 2 screws until the groove along each screw circumference catches on the screw case.

  1. B127893E01
    Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screwdriver, disconnect the 2 airbag connectors.

    CAUTION:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Disconnect the horn connector and remove the steering pad.


3. REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Navigation System)

B132929
  1. Disconnect the connectors.

  1. Remove the 2 screws.

  1. Detach the 2 claws and remove the steering pad switch.


4. REMOVE STEERING PAD SWITCH ASSEMBLY (w/o Navigation System)

B134588
  1. Disconnect the connectors.

  1. Remove the screw.

  1. Detach the claw and remove the steering pad switch.

← COMPONENTS (from Nov 2005)REMOVAL (from Jan 2007) →