2005-2008 RAV4 · Service Manual BRAKE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2007


CHECK BRAKE BOOSTER ASSEMBLY

C111618E01
  1. Airtightness check

    1. Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times.

    2. Make sure the booster is airtight. Check that the distance the pedal can be depressed decreases gradually in correlation with each subsequent press of the pedal.
      If the pedal is not as specified, check the check valve.
      If the check valve is normal, replace the booster.

    3. Start the engine. Depress and hold down the pedal, and stop the engine.

    4. Make sure the booster is airtight. Hold the pedal for 30 seconds and check that there is no change in the pedal reserve distance.
      If the pedal is not as specified, check the check valve.
      If the check valve is normal, replace the booster.

  1. Operation check

    1. Stop the engine.

    2. C128542
      Depress the pedal several times and check that there is no change in the pedal reserve distance.

    3. C128543
      Depress and hold down the pedal, and start the engine. Check that the pedal can only be depressed slightly.
      If the pedal is not as specified, check the check valve.
      If the check valve is normal, replace the booster.


CHECK BRAKE VACUUM CHECK VALVE ASSEMBLY

C128544E01
  1. Check the check valve.

    1. Slide the clip and disconnect the vacuum hose.

    2. Remove the check valve from the booster.

    3. Check that there is ventilation from the booster to the engine, and no ventilation from the engine to the booster.
      If the results are not as specified, replace the check valve assembly.

← COMPONENTS (from Aug 2007)REMOVAL (from Aug 2007) →