2005-2008 RAV4 · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT WHEEL

2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


3. REMOVE FRONT FLEXIBLE HOSE

  1. C128557E01
    Disconnect the brake tube (labeled A) from the flexible hose with union nut wrench (10 mm) while holding the flexible hose with a wrench.

    NOTICE:
    1. Do not bend or damage the brake tube.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

  1. Remove the clip (labeled B).

  1. Remove the 2 bolts (labeled C, D) and then remove the flexible hose clamp (labeled E) from the knuckle.

  1. C133753E02
    Remove the sensor clamp and flexible hose clamp from the flexible hose bracket.

  1. C127057
    Remove the union bolt and gasket, and then remove the flexible hose from the disc brake cylinder.

← REMOVAL (Nov 2005 – Jul 2008)INSTALLATION (Nov 2005 – Dec 2006) →