2005-2008 RAV4 · Service Manual BRAKE

INSPECTION

Inspection · Vehicles built from Nov 2005

NOTICE:
  1. The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure to tip of the master cylinder points downward when handling the master cylinder.
  2. Make sure foreign matter does not attach to the master cylinder's piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.


INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD

HINT:
Adjust the booster push rod when the master cylinder is replaced with a new one. Adjustment is not necessary when the master cylinder is reinstalled and the booster is replaced with a new one.

  1. G028332E02
    Set SST on the master cylinder and lower the rod of SST until it just touches the piston.
    SST
    09737-00013  

  1. Apply chalk to the flat tip of the SST rod. Turn SST upside down and measure the clearance between the brake booster push rod and SST.

    Standard clearance:
    -0.21 to 0 mm (-0.0083 to 0 in.)

    If there is clearance between the SST main body and the shell of the brake booster, the push rod is protruding too far. If the chalk does not stick to the tip of the brake booster push rod, the push rod protrusion is insufficient.

  1. C128539E01
    If the clearance is not within the standard, adjust the length by holding the rod using SST and turning the tip of the rod using a 7 mm socket driver.
    SST
    09737-00020  

    NOTICE:
    Check the push rod clearance again after adjusting.

← DISASSEMBLY (from Nov 2005)REASSEMBLY (from Nov 2005) →