REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE ROOF HEADLINING ASSEMBLY (for Short Body) |
 |
Remove the roof headlining (Click here).
| 3.
REMOVE ROOF HEADLINING ASSEMBLY (for Long Body) |
 |
Remove the roof headlining (Click here).
| 4.
REMOVE SLIDING ROOF SIDE GARNISH LH |
 |
Using a screwdriver, detach the claws and remove the garnish.
- HINT:
- Tape the screwdriver tip before use.
| 5.
REMOVE SLIDING ROOF SIDE GARNISH RH |
 |
- HINT:
- Use the same procedures described for the LH side.
| 6.
REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY |
 |
Using a T25 "torx" driver, remove the 4 screws and glass.
Pull the glass upward to remove it.
| 7.
REMOVE SLIDING ROOF WEATHERSTRIP |
|
| 8.
DISCONNECT SLIDING ROOF DRAIN HOSE |
 |
Disconnect the 4 drain hoses.
| 9.
REMOVE SLIDING ROOF HOUSING ASSEMBLY |
 |
Remove the 4 bolts, 8 nuts and housing.
- NOTICE:
- Be careful not to damage the curtain shield airbag when removing the housing.