INSPECTION
Inspection · Vehicles built from Nov 2005
| INSPECT SOLAR SENSOR |
![]() ![]() |
Using an ohmmeter, connect the positive lead to terminal 2 and the negative lead to terminal 1, then measure the resistance between the terminals.
- Standard resistance:
Tester Connection
Connection
Specified Condition
1 - 2
Sensor subject to electric light
Except ∞ Ω
1 - 2
Sensor covered with a cloth
∞ Ω
- NOTICE:
- The connection procedure for using a digital tester such as a TOYOTA electrical tester is shown above. When using an analog tester, connect the positive (+) lead to terminal 1 and the negative (-) lead to terminal 2 of the A/C solar sensor.
- HINT:
- As the inspection light is moved away from the sensor, the voltage increases.
- Use an incandescent lamp for inspection. Bring it within 30 cm (11.8 in.) of the A/C solar sensor.
- As the inspection light is moved away from the sensor, the voltage increases.
- If the result is not as specified, replace the solar sensor.


