2005-2008 RAV4 · Service Manual BRAKE

C1203/53 ECM Communication Circuit Malfunction

Diagnostic trouble codes · Vehicles built Aug 2007 – Jul 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008

DESCRIPTION

The circuit is used to send TRC and VSC control information from the skid control ECU to the ECM, and engine control information from the ECM to the skid control ECU.
DTC No.
DTC Detection Condition
Trouble Area
C1203/53
Information relating to engine, drive source or destination stored in ECM does not match information stored in skid control ECU.
ECM

INSPECTION PROCEDURE

HINT:
Check that the part numbers of the installed ECM and skid control ECU are correct before performing the following procedure.


1. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE ECM


← C1203/53 ECM Communication Circuit Malfunction (Jan 2007 – Jul 2007)C1210 Zero Point Calibration of Yaw Rate Sensor Undone (+ C1336) (from Aug 2008) →