B2311 Driver Door Motor Malfunction
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
The driver door power window regulator motor is driven by operating the power window regulator master switch. The driver door power window regulator motor has motor, regulator, and ECU functions.DTC B2311 is output when the driver door power window regulator motor assembly has a malfunction, or the ECU built into the regulator motor assembly determines that the fully closed window position has deviated approximately 20 mm (0.79 in.) or more from the normal position.
- NOTICE:
- The power window control system uses a multiplex communication system (LIN). Inspect the communication function by following HOW TO PROCEED WITH TROUBLESHOOTING. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
- When the power window regulator motor assembly (on the driver side) is reinstalled or replaced, the power window control system must be initialized.
- After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the AUTO UP function is used. In such cases, the AUTO UP function can be resumed by repeating the following operation at least 5 times:
- Close the power window by fully pulling up the power window switch and holding it in the AUTO UP position.
- Open the power window by fully pushing down the switch.
- The power window control system uses a multiplex communication system (LIN). Inspect the communication function by following HOW TO PROCEED WITH TROUBLESHOOTING. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2311 |
When either condition below is met:
|
|
INSPECTION PROCEDURE
- NOTICE:
- When using the intelligent tester to troubleshoot the LIN communication line: Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (POWER WINDOW UP/DOWN) |
Perform the Active Test, using the intelligent tester to generate a control command, and then check the power window operation.
Power window regulator motor (Power window ECU) Item
Test Details
Diagnostic Note
Power Window
OFF / UP / DOWN (OFF)
-
- OK:
- Driver side power window operates normally.
- CAUTION:
- Be careful to avoid injuries as this test causes vehicle parts to move.
- During the Active Test, the jam protection function does not operate.
|
|
||||
| OK | |
| 2. INITIALIZE POWER WINDOW CONTROL SYSTEM |
Initialize the power window regulator motor assembly (on the driver side) (Click here).
Check that the power window operates normally by opening and closing the window.
- OK:
- Driver side power window operates normally.
|
|
||||
| OK | |
| 3. CHECK WHETHER PARTS HAVE BEEN INSTALLED CORRECTLY |
Check that the power window components (on the driver side) are installed correctly.
- OK:
- Power window components (on driver side) are installed correctly.
- HINT:
- When the power window components are installed correctly, the problem has been caused by battery disconnection while the ignition switch is on (IG), improper installation of the power window components or the motor being overheated.
|
|
||||
| OK | ||
| ||
