B1249 Double Locking ECU Communication Stop
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
DTC B1249 is output when the communication between the double door lock ECU and the main body ECU stops for more than 10 seconds.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1249 |
No communication from double door lock ECU for more than 10 seconds |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (COMMUNICATION DOUBLE LOCKING) |
Check the Data List to ensure the proper operation of the double door lock ECU.
Main body ECU Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Communication Double Locking
Connection status between double door lock ECU and main body ECU / OK or STOP
OK: Connection
STOP: No connection
-
- OK:
- Doors can lock / unlock.
|
|
||||
| NG | |
| 2. CHECK WIRE HARNESS (DOUBLE DOOR LOCK ECU - BODY ECU, BATTERY AND BODY GROUND) |
Disconnect the E82 double door lock ECU connector.

Disconnect the E18 main body ECU connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E82-9 (MPX1) - E18-23 (LIN2)
Below 1 Ω
E82-9 (MPX1) or E18-23 (LIN2) - Body ground
10 kΩ or higher
E82-14 (GND) - Body ground
Below 1 Ω
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Specified Condition
E82-1 (+B) - Body ground
10 to 14 V
|
|
||||
| OK | ||
| ||
