2005-2008 RAV4 · Service Manual HEATER & AIR CONDITIONING SYSTEM

Back-up Power Source Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This is the back-up power source circuit for the air conditioning amplifier. Power is supplied even when the ignition switch is turned off and is used for functions such as the diagnostic trouble code memory.

WIRING DIAGRAM

E123561E01

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-B2)
  1. Remove the ECU-B2 fuse from the engine room No. 2 relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BATTERY)
E118637E11
  1. Disconnect the E41 amplifier connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    E41-21 (B) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3. CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BODY GROUND)
E118637E12
  1. Disconnect the E41 amplifier connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E41-14 (GND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← IG Power Source Circuit (from Nov 2005)PRECAUTION (from Nov 2005) →