Back-up Power Source Circuit
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
This is the back-up power source circuit for the air conditioning amplifier. Power is supplied even when the ignition switch is turned off and is used for functions such as the diagnostic trouble code memory.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FUSE (ECU-B2) |
Remove the ECU-B2 fuse from the engine room No. 2 relay block.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BATTERY) |
![]() ![]() |
Disconnect the E43 amplifier connector.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Specified Condition
E43-1 (B) - Body ground
10 to 14 V
|
|
||||
| OK | ||
| ||

