2005-2008 RAV4 · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT OIL JET

  1. A126890
    Check the oil jet for damage or clogging.
    If necessary, repair the cylinder block.


INSPECT OIL PUMP RELIEF VALVE

  1. A114340
    Check the relief valve.

    1. Coat the valve with engine oil, and then check that the valve falls smoothly into the valve hole by its own weight.
      If it does not, replace the relief valve. If necessary, replace the oil pump assembly.


INSPECT OIL PUMP ROTOR

  1. B011420E02
    Check the side clearance.

    1. Using a feeler gauge and precision straightedge, measure the clearance between the rotors and precision straightedge.

      Standard clearance:
      0.100 to 0.170 mm (0.0039 to 0.0067 in.)

      Maximum clearance:
      0.325 mm (0.0128 in.)

      If the side clearance is greater than the maximum, replace the oil pump assembly.

  1. A114223E01
    Check the tip clearance.

    1. Using a feeler gauge, measure the clearance between the drive and driven rotor tips.

      Standard clearance:
      0.080 to 0.160 mm (0.0031 to 0.0063 in.)

      Maximum clearance:
      0.35 mm (0.0138 in.)

      If the tip clearance is greater than the maximum, replace the oil pump assembly.

  1. B011422E01
    Check the body clearance.

    1. Using a feeler gauge, measure the clearance between the driven rotor and pump body.

      Standard clearance:
      0.100 to 0.170 mm (0.0039 to 0.0067 in.)

      Maximum clearance:
      0.325 mm (0.01128 in.)

      If the body clearance is greater than the maximum, replace the oil pump assembly.


INSPECT OIL PUMP DRIVE CHAIN AND 2 OIL PUMP SPROCKETS

  1. A126891E01
    Using vernier calipers, measure the length of the 8 links with the chain fully stretched.

    Maximum chain elongation:
    52.4 mm (2.063 in.)

    If the elongation is greater than the maximum, replace the chain.

    HINT:
    Make the measurements at 3 or more places selected at random.

  1. Wrap the chain around the oil pump sprocket.

  1. A126892
    Using vernier calipers, measure the sprocket diameter with the chain.

    NOTICE:
    Vernier calipers must contact the chain rollers when measuring.

    Minimum sprocket diameter (with chain):
    Crankshaft 48.2 mm (1.898 in.)
    Oil pump drive shaft 48.2 mm (1.898 in.)

    If the diameter is less than the minimum, replace the chain and sprockets.


INSPECT CHAIN TENSIONER PLATE

A126893E01
  1. Measure the chain tensioner plate wear.

    Maximum wear:
    0.5 mm (0.020 in.)

    If the wear is greater than the maximum, replace the chain tensioner plate.

← DISASSEMBLY (from Nov 2005)REASSEMBLY (from Nov 2005) →