DISASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1.
REMOVE RADIO SETTING CONDENSER |
 |
- Remove the bolt and condenser.
| 2.
REMOVE OIL PRESSURE SWITCH |
 |
- Using a 24 mm deep socket wrench, remove the sensor.
| 3.
REMOVE ENGINE COOLANT TEMPERATURE SENSOR |
 |
- Using SST, remove the sensor and gasket.
- SST
- 09817-33190
| 4.
REMOVE CAMSHAFT POSITION SENSOR |
 |
- Remove the bolt and sensor.
| 5.
REMOVE NO. 2 CAMSHAFT BEARING |
 |
- Remove the No. 2 camshaft bearing.
| 6.
REMOVE NO. 1 CAMSHAFT BEARING |
 |
- Remove the No. 1 camshaft bearing.
| 7.
REMOVE VALVE LIFTER |
 |
- HINT:
- Arrange the valve lifters in the correct order.
| 8.
REMOVE INTAKE VALVE |
 |
Place the cylinder head on wooden blocks.
- Using SST, compress the spring, then remove the 2 retainer locks.
- SST
- 09202-70020
(09202-00010)
- Remove the retainer, spring and valve from the cylinder head.
- HINT:
- Arrange the removed parts in the correct order.
| 9.
REMOVE EXHAUST VALVE |
 |
Place the cylinder head on wooden blocks.
- Using SST, compress the spring, then remove the 2 retainer locks.
- SST
- 09202-70020
(09202-00010)
- Remove the retainer, spring and valve from the cylinder head.
- HINT:
- Arrange the removed parts in the correct order.
| 10.
REMOVE VALVE SPRING SEAT |
 |
- Using compressed air and a magnetic finger, remove the spring seat by blowing air.
- HINT:
- Arrange the valves, valve springs, spring seats and spring retainers in the correct order.
| 11.
REMOVE VALVE STEM OIL SEAL |
 |
- Using needle-nose pliers, remove the 16 oil seals.