REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() ![]() |
Using a screwdriver, detach the 4 clips, 6 claws and remove the instrument cluster finish panel.
- HINT:
- Tape the screwdriver tip before use.
| 3. REMOVE COMBINATION METER ASSEMBLY |
![]() ![]() |
Remove the 2 screws.
Pull the combination meter as indicated by the arrow in the illustration to detach the 2 clips.
Disconnect the connector and remove the combination meter.



