2005-2008 RAV4 · Service Manual CRUISE CONTROL SYSTEM

INSTALLATION

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. INSTALL CRUISE CONTROL MAIN SWITCH

B127290E10
  1. Install the switch with the 2 screws.

    Torque:
    1.7 to 3.0 N*m{ 17.34 to 30.60 kgf*cm , 15.04 to 26.55 in.*lbf }

  1. Connect the connector.


2. INSTALL STEERING PAD ASSEMBLY

B127893E01
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 airbag connectors.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.

  1. B130245E02
    Using a T30 "torx" driver, install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

4. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).

← INSTALLATION (Nov 2005 – Dec 2006)PRECAUTION (from Nov 2005) →