2005-2008 RAV4 · Service Manual SECURITIES

DATA LIST / ACTIVE TEST

System information · Vehicles built from Nov 2005


READ DATA LIST

HINT:
Using the intelligent tester Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the tester ON.

  3. Select the following menu items: Body / Immobiliser / Data List.

  4. Check the results by referring to the table below.

Certification ECU 
Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Ignition Switch
Ignition switch on (IG) signal / ON or OFF
ON: Ignition switch on (ACC, IG) or start
OFF: Ignition switch off
-
ACC Switch
Ignition switch on (ACC) signal / ON or OFF
ON: Ignition switch on (ACC, IG) or start
OFF: Ignition switch off
-
ID-BOX Sleep Condition
ID code box sleep condition / YES or NO
-
-
ID-BOX Start Condition
ID code box wake up signal / YES or NO
-
-
EFI Code Receive
SFI (ECD) code receive / OK or NG
OK: SFI (ECD) code is received
NG: SFI (ECD) code is not received
-
Engine Start Request
ID code box start request condition / OK or NG
OK: Start request condition signal is received
NG: Start request condition signal is not received
-
3bit Code Request
3 bit code request / OK or NG
OK: 3 bit code is received
NG: 3 bit code is not received
-
S Code Check
Code verification result / OK or NG
OK: Verification confirmed
NG: Verification is not confirmed
-
L Code Check
Code verification result / OK or NG
OK: Verification confirmed
NG: Verification is not confirmed
-
← DTC CHECK / CLEAR (from Jan 2007)DIAGNOSTIC TROUBLE CODE CHART (Nov 2005 – Dec 2006) →