B278A Short to GND in Immobiliser System Power Source Circuit
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
This DTC is output when the ignition switch power source supply line is open or short.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B278A |
Ignition switch power source supply line is open or short |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WIRE HARNESS (CERTIFICATION ECU - ENGINE SWITCH) |


Disconnect the E63 ECU connector.
Disconnect the E31 switch connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E63-30 (VC5) - E31-14 (VC5)
Below 1 Ω
E63-40 (AGND) - E31-8 (AGND)
E63-30 (VC5) or E31-14 (VC5) - Body ground
10 kΩ or higher
E63-40 (AGND) or E31-8 (AGND) - Body ground
|
|
||||
| OK | |
| 2. CHECK ENGINE SWITCH (OPERATION) |
Temporarily replace the engine switch with a new or normally functioning one.
Check that the engine starts normally.
- OK:
- Engine starts normally.
|
|
||||
| OK | ||
| ||
