INSTALLATION
Removal / installation · Vehicles built from Nov 2005
| 1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
![]() ![]() |
Using SST, install the sensor to the front exhaust pipe.
- SST
- 09224-00010
- Torque:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
- 44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST
- HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
- Make sure SST and wrench are connected in a straight line.
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
Connect the sensor connector.
| 2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 3. CHECK FOR EXHAUST GAS LEAKS |


