2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2007


1. INSTALL HEATED OXYGEN SENSOR (for Bank 2)

  1. A174095E01
    Using SST, install the sensor to the exhaust pipe.
    SST
    09224-00010  

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
    44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
    2. Make sure that SST and a wrench are connected in a straight line.

  1. Connect the sensor connector.


2. INSTALL HEATED OXYGEN SENSOR (for Bank 1)

  1. A173719E01
    Using SST, install the sensor to the exhaust pipe.
    SST
    09224-00010  

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
    44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
    2. Make sure that SST and a wrench are connected in a straight line.

  1. Connect the sensor connector.


3. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY (for Bank 1)
(Click here)

4. INSPECT FOR EXHAUST GAS LEAK
← INSPECTION (from Aug 2007)PRECAUTION (from Nov 2005) →