2005-2008 RAV4 · Service Manual COMMUNICATION SYSTEM

PRECAUTION

Precautions · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1.IGNITION SWITCH EXPRESSION

HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (position)
Engine Switch (condition)
Ignition Switch off
LOCK
Off
Ignition Switch on (IG)
ON
On (IG)
Ignition Switch on (ACC)
ACC
On (ACC)
Engine Start
START
Start


2.PRECAUTION
  1. Turn the ignition switch off before measuring the resistance of the main wire and the branch wire.

  2. For Auto:
    After the ignition switch is turned off, check that the key reminder warning system is not in operation.

  3. For Reminder:
    After the ignition switch is turned off, check that the key reminder warning system and light reminder buzzer are not in operation.

  4. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any switches or doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

    HINT:
    Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


3.STEERING SYSTEM HANDLING PRECAUTIONS
  1. Care must be taken when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazards when driving.


4.SRS AIRBAG SYSTEM HANDLING PRECAUTIONS
  1. This vehicle is equipped with an SRS (Supplemental Restraint System) such as the driver airbag and front passenger airbag. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may lead to a serious accident. Before servicing (including installation/removal, inspection and replacement of parts), be sure to read the precautionary notice for the Supplemental Restraint System (Click here).


5.BUS LINE REPAIR

  1. E120441
    After repairing the bus line with solder, wrap the repaired part with vinyl tape (Click here).

    NOTICE:
    1. The CANL bus line and CANH bus line must be installed together.
    2. When installing, twist them together.
    3. CAN bus lines are likely to be influenced by noise if the bus lines are not twist together.
    4. The difference in length between the CANL bus line and CANH bus line should be less than 100 mm (3.937 in.).
    5. Leave approximately 80 mm (3.150 in.) loose in the twisted wires around the connectors.

  2. E120442E01
    Do not use bypass wiring between the connectors.

    NOTICE:
    The feature of the twisted wire harness will be lost if bypass wiring is used.


6.CONNECTOR HANDLING

  1. E120443E01
    When inserting tester probes into a connector, insert them from the rear of the connector.

  2. E120444E01
    Use a repair wire to check the connector if it is impossible to check resistance from the rear of the connector.

← PRECAUTION (Nov 2005 – Dec 2006)PARTS LOCATION (from Nov 2005) →