2005-2008 RAV4 · Service Manual ENGINE

REPLACEMENT

Removal / installation · Vehicles built from Nov 2005


1. REPLACE TIMING CHAIN COVER OIL SEAL
  1. Place the timing chain cover on wooden blocks.

  1. A111269E02
    Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole.

  1. A111284E01
    Using SST and a hammer, tap in a new oil seal to a depth between 0 to 0.6 mm (0 to 0.024 in.) from the timing chain cover edge.
    SST
    09223-50010  

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap the oil seal at an angle.

  1. Apply MP grease to the lip of the oil seal.

← INSPECTION (from Nov 2005)REASSEMBLY (from Nov 2005) →