2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE COVER

  1. A123518
    Detach the 4 clips and remove the engine cover.


3. REMOVE AIR CLEANER CAP

  1. A124927E01
    Disconnect the mass air flow meter connector.

  1. Disconnect the wire harness clamp.

  1. Unhook the 3 hook clamps, and then remove the air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


4. REMOVE AIR CLEANER CASE

  1. A124928E01
    Disconnect the wire harness clamp and remove the 3 bolts and air cleaner case.


5. REMOVE ECM

  1. A124570
    Remove the 3 bolts holding the ECM brackets.

  1. A124571E01
    Disconnect the 2 ECM connectors.

    1. Raise the 2 levers while pushing the locks on the 2 levers, and remove the 2 ECM connectors.

  1. Remove the ECM.

  1. A124573
    Remove the 4 screws and 2 ECM brackets.

← COMPONENTS (from Nov 2005)INSTALLATION (Nov 2005 – Dec 2006) →