REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE BATTERY |
Loosen the nut and remove the bolt and battery clamp.
Remove the battery.
Remove battery tray.
Remove the 4 bolts and battery carrier.
Remove the 2 bolts and battery bracket reinforcement.
| 3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Disconnect the switch connector.

Remove the nut and disconnect the control cable from the control shaft lever.

Remove the nut, washer and control shaft lever.

Using a screwdriver, pry off the lock plate.

Remove the nut and lock plate.
Remove the 2 bolts and pull out the switch.

