2005-2008 RAV4 · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

C134995E01
  1. Install the 5 shift solenoid valves with the 5 bolts and 4 plates.

    Torque:
    6.6 N*m{ 67 kgf*cm , 58 in.*lbf } for bolt A
    11 N*m{ 112 kgf*cm , 9 ft.*lbf } for bolt B

    HINT:
    Each bolt length is indicated below.

    Bolt length:
    12 mm (0.47 in.) for Bolt A
    45 mm (1.77 in.) for Bolt B

  1. C050017E01
    Install the spring and check ball body.

  1. D003553E10
    Align the groove of the manual valve with the pin of lever.

  1. Install the 17 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    NOTICE:
    1. Push the valve body against the accumulator piston spring and the check ball body to install it.
    2. Tighten the bolts marked by * in the illustration first temporarily because they are positioning bolts.

    HINT:
    Each bolt length is indicated below.

    Bolt length:
    25 mm (0.984 in.) for Bolt A
    41 mm (1.614 in.) for Bolt B
    45 mm (1.771 in.) for Bolt C


2. INSTALL TRANSMISSION WIRE

C130917E01
  1. Coat the O-ring with ATF.

  1. Install the ATF temperature sensor with the lock plate and bolt.

    Torque:
    6.6 N*m{ 67 kgf*cm , 58 in.*lbf }

  1. Connect the 5 shift solenoid valve connectors.


3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

C069150E01
  1. Coat a new O-ring with ATF.

  1. Install the O-ring to the oil strainer.

  1. D009179E01
    Install the oil strainer with the 3 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }


4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

C134981E01
  1. Install the 3 magnets in the oil pan.

  1. C083111E01
    Install a new gasket, oil pan with the 18 bolts.

    Torque:
    7.6 N*m{ 77 kgf*cm , 67 in.*lbf }


5. INSTALL NO. 1 ENGINE UNDER COVER

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. ADD AUTOMATIC TRANSAXLE FLUID

Fluid type:
Toyota Genuine ATF WS


8. INSPECT TRANSAXLE FLUID LEVEL
  1. Inspect the fluid level (Click here).


9. PERFORM RESET MEMORY
  1. Perform the RESET MEMORY procedures (A/T initialization) (Click here).

← REMOVAL (from Nov 2005)PARTS LOCATION (from Nov 2005) →