ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
- HINT:
- The type of ignition switch on this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the ''EXPRESSION OF IGNITION SWITCH'' precaution (Click here).
| CHECK SHIFT LOCK OPERATION |
Move the shift lever to P.
Turn the ignition switch off.
Check that the shift lever cannot be moved to any position other than P.
Turn the ignition switch on (IG), depress the brake pedal and check that the shift lever can be moved to other positions.
| CHECK SHIFT LOCK RELEASE BUTTON OPERATION |
When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position other than P. If the operation cannot be performed as specified, check the shift lever assembly.
| REMOVE KEY INTERLOCK OPERATION |
Turn the ignition switch on (IG).
Depress the brake pedal and move the shift lever to any position other than P.
Check that the ignition switch cannot be turned off.
Move the shift lever to P, turn the ignition switch off and check that the key can be removed. If the results are not as specified, inspect the shift lock control unit.
| CHECK SHIFT LOCK CONTROL UNIT ASSEMBLY |
![]() ![]() |
Measure the voltage of the connector.
- HINT:
- Do not disconnect the shift lock control ECU connector.
- Standard voltage:
Tester Connection
Condition
Specified Condition
6 (ACC) - 1 (E)
Ignition switch on (IG)
10 to 14 V
6 (ACC) - 1 (E)
Ignition switch on (ACC)
10 to 14 V
6 (ACC) - 1 (E)
Ignition switch off
Below 1 V
4 (STP) - 1 (E)
Depress brake pedal
10 to 14 V
4 (STP) - 1 (E)
Release brake pedal
Below 1 V
5 (KLS+) - 1 (E)
Ignition switch on (ACC) and shift lever on P
Below 1 V
5 (KLS+) - 1 (E)
Ignition switch on (ACC) and shift lever not on P
7.5 to 11 V
5 (KLS+) - 1 (E)
Ignition switch on (ACC) and shift lever not on P (after approx. 1 second)
6 to 9 V
8 (IG) - 1 (E)
Ignition switch on (IG)
10 to 14 V
8 (IG) - 1 (E)
Ignition switch off
Below 1 V
the resistance of the connector.

- HINT:
- Do not disconnect the shift lock control ECU connector.
- Standard resistance:
Tester Connection
Measuring Condition
Specified Condition
1 (E) - Body ground
Always
Below 1 Ω

