2005-2008 RAV4 · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Aug 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. INSTALL FLOOR SHIFT ASSEMBLY

C127814
  1. Connect the 2 connectors and attach the clamp.

  1. Install the floor shift with the 4 bolts.


2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

C118484E01
  1. Turn the nut of the control cable and push in the lock.

  1. C127841
    Install the control cable onto the shift lever retainer.

    NOTICE:
    1. Install the cable with the protruding portion of the cable outer facing upward.

    2. C127842E01
      After installing, check that the lock of the cable outer is protruding beyond portion A-A, as shown in the illustration.

  1. C130919
    Connect the control cable to the shift lever.

    NOTICE:
    Connect the control cable so that the adjusting mechanism lock of the control cable is installed on the driver side of the vehicle.


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

4. INSPECT SHIFT LEVER POSITION
  1. When shifting the lever from P to the R position with the ignition switch on (IG) and the brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.

  1. Start the engine and make sure that the vehicle moves forward when shifting the lever from N to the D position and moves rearward when shifting the lever to the R position.
    If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.


5. ADJUST SHIFT LEVER POSITION
  1. Shift the shift lever to the N position

  1. C117121E01
    Slide the adjuster case cover in the direction shown in the illustration and pull out the lock piece.

  1. Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.

  1. C117120E01
    Press the lock piece into the adjuster case and lock it.

  1. C117119E01
    Slide the cover in the direction shown in the illustration.

    NOTICE:
    Slide the cover past the protrusion of the lock piece.

  1. Inspect the operation after the adjustment.


6. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
  1. Install the rear console box (Click here).


7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
← INSTALLATION (Jan 2007 – Jul 2007)COMPONENTS (from Nov 2005) →