REMOVAL
Removal / installation · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
| 1.
REMOVE ENGINE ASSEMBLY WITH TRANSAXLE |
 |
Remove the engine with transaxle (Click here).
| 2.
DRAIN AUTOMATIC TRANSAXLE FLUID |
 |
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
-
Torque:
- 47 N*m{
479 kgf*cm
, 35 ft.*lbf
}
| 3.
REMOVE STARTER ASSEMBLY |
 |
Disconnect the starter connector.
Open the terminal cap, and remove the nut and disconnect the starter wire.
- Remove the 2 bolts and starter.
| 4.
DISCONNECT WIRE HARNESS |
 |
Disconnect the park/neutral position switch connector.
Disconnect the transaxle wire connector.
Disconnect the speed sensor connectors.
Disconnect the wire harness clamps.
| 5.
REMOVE TRANSMISSION OIL COOLER HOSE AND TUBE |
 |
Remove the oil cooler hoses and tube (Click here).
| 6.
REMOVE ENGINE MOUNTING BRACKET RR |
 |
Remove the 3 bolts and mounting bracket.
| 7.
REMOVE ENGINE MOUNTING BRACKET FR |
 |
- Remove the 3 bolts and mounting bracket.
| 8.
REMOVE ENGINE MOUNTING BRACKET LH |
 |
Remove the 3 bolts and mounting bracket.
| 9.
REMOVE AUTOMATIC TRANSAXLE ASSEMBLY |
 |
Remove the flywheel housing under cover.
Turn the crankshaft to gain access and remove the 6 bolts while holding the crankshaft pulley bolt with a wrench.
- Remove the 4 lower side mounting bolts.
- Remove the 5 upper side mounting bolts.
Separate and remove the automatic transaxle.
| 10.
REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
 |
Remove the ATF dipstick.
Remove the bolt and oil filler tube.
| 11.
REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET |
 |
Remove the 2 bolts and cable bracket.
| 12.
REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY |
|