2005-2008 RAV4 · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT PACK CLEARANCE OF DIRECT CLUTCH

D009210E01
  1. Install the direct clutch and needle roller bearing on the transaxle rear cover.

  1. Using a dial indicator, measure the forward clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi)

    Standard pack clearance:
    0.515 to 0.825 mm (0.0203 to 0.0324 in.)

    If the pack clearance is not as specified, inspect the discs, plates and flange.


INSPECT DIRECT MULTIPLE DISC CLUTCH DISC

D004079E01
  1. Check to see if the sliding surface of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    HINT:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.


INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY

D009211E03
  1. Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    22.58 mm (0.8898 in.)

← DISASSEMBLY (from Nov 2005)REASSEMBLY (from Nov 2005) →