2005-2008 RAV4 · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSPECT PACK CLEARANCE OF UNDERDRIVE CLUTCH

D008123E01
  1. Install the underdrive clutch to the transaxle.

    NOTICE:
    Be careful not to damage the oil seal rings.

  1. Install a dial indicator as shown in the illustration.

  1. D003700E01
    Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0kgf/cm2, 57 psi)

    Standard pack clearance:
    1.51 to 1.90 mm (0.0594 to 0.0748 in.)

    If the pack clearance is not as specified, inspect the discs, plates and flange.


2. REMOVE NO. 1 UNDERDRIVE CLUTCH DISC

D003701E02
  1. Using a screwdriver, pry out the underdrive clutch flange snap ring.

  1. C129394
    Remove the flange, 3 discs and 3 plates from the underdrive clutch drum.


3. INSPECT NO. 1 UNDERDRIVE CLUTCH DISC

D004077E01
  1. Check to see if the sliding surface of the disc, plate and flange are worn or burnt. If necessary, replace them.

    HINT:
    1. If the lining of the discs is peeling off or discolored, or even if a part of the printed mark is defaced, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.


4. INSPECT UNDERDRIVE CLUTCH DRUM SUB-ASSEMBLY

D008129E02
  1. Using a caliper gauge measure the inside diameter of the underdrive clutch drum bush.

    Standard drum bush:
    37.06 to 37.08 mm (1.4591 to 1.4598 in.)

    Maximum drum bush:
    37.13 mm (1.4618 in.)

    If the inside diameter is greater then the maximum, replace the underdrive clutch drum sub-assembly.


5. REMOVE UNDERDRIVE CLUTCH DRUM O-RING

D004078E01

6. REMOVE UNDERDRIVE CLUTCH PISTON SET

D003703E02
  1. Place SST on the clutch balancer and compress the spring with a press.

    SST
    09350-32014   (09351-32070)

  1. Using a snap ring expander, remove the snap ring.

    NOTICE:
    1. Stop the press when the spring sheet is lowered to a position 1 to 2 mm (0.04 to 0.08 in.) from the snap ring groove.
    2. This prevents the spring sheet from being deformed.
    3. Do not expand the snap ring excessively.

  1. C056359E02
    Remove the clutch balancer from the underdrive clutch drum.

  1. C056360E03
    Remove the piston return spring from the underdrive clutch drum.

  1. D003705E01
    Install the underdrive clutch to the transaxle.

    NOTICE:
    Be careful not to damage the oil seal rings.

  1. Holding the underdrive clutch piston with your hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle case to remove the underdrive clutch piston.


7. INSPECT UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY

D003824E02
  1. Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    17.14 mm (0.6752 in.)

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →