DISASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1. REMOVE UNDERDRIVE PLANETARY GEAR PRELOAD |
![]() ![]() |
Using SST, fix the underdrive planetary gear.
- SST
- 09387-00050
Using SST and a torque wrench, measure the turning torque of the underdrive planetary gear in place while rotating the torque wrench at 60 rpm.

- SST
- 09387-00050
- Torque:
- Turning torque at 60 rpm:
- 0.10 to 4.41 N*m{ 1.0 to 45 kgf*cm , 0.9 to 39 in.*lbf }
- HINT:
- Use a torque wrench with a fulcrum length of 160 mm (6.3 in.)
| 2. REMOVE UNDERDRIVE INPUT SHAFT NUT |
![]() ![]() |
- SST
- 09930-00010
(09931-00010, 09931-00020)
09387-00050
09564-16020
Using SST, loosen the staked part of the nut.
Clamp the underdrive planetary gear in soft jaw vise.

- NOTICE:
- Be careful not to damage the differential drive pinion.
Using SST, remove the lock nut.

- SST
- 09387-00050
| 3. REMOVE CYLINDRICAL ROLLER BEARING INNER RACE |
![]() ![]() |
Using SST, remove the cylindrical roller bearing race inner.
- SST
- 09950-00020
09950-00030
09950-60010 (09951-00340)
| 4. REMOVE UNDERDRIVE PLANETARY GEAR ASSEMBLY |
![]() ![]() |
Using SST and a press, remove the differential drive pinion, parking lock gear, counter driven gear with underdrive planetary ring gear and front tapered roller bearing.
- SST
- 09387-00050
Clamp the underdrive planetary gear in soft jaw vise.

Using SST, remove the rear tapped roller bearing from the underdrive planetary gear.
- SST
- 09950-00020
09950-00030
09950-60010 (09951-00340)
| 5. REMOVE UNDERDRIVE PLANETARY RING GEAR |
![]() ![]() |
Using snap ring pliers, remove the snap ring.
Remove the underdrive planetary ring gear from the counter driven gear.






