2005-2008 RAV4 · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL UNDERDRIVE PLANETARY RING GEAR

D008112E02
  1. Install a new snap ring to the outer race of the tapered roller bearing.

  1. D008113E01
    Using a piston ring compressor, squeeze the snap ring.

  1. D008114E01
    Using SST a press, press in the outer race of the tapered roller bearing.
    SST
    09950-60020   (09951-00890)
    09950-70010   (09951-07100)

  1. D003827E04
    Install the underdrive planetary ring gear to the counter driven gear.

  1. D008115E02
    Using snap ring pliers, install the snap ring.


2. INSTALL UNDERDRIVE PLANETARY GEAR ASSEMBLY

D003692E01
  1. Using a press, press in the rear tapered roller bearing to the underdrive planetary gear.

    NOTICE:
    Press in the bearing until it becomes flat at the bottom

  1. D008117E01
    Install the counter driven gear with planetary ring gear to the underdrive planetary gear.

  1. D003693E01
    Using SST and a press, press in the front tapered roller bearing.
    SST
    09214-76011  

    NOTICE:
    Press in the counter driven gear while rotating it.

  1. D003694E02
    Using a press, press in the parking lock gear.

    NOTICE:
    Press in the counter driven gear while rotating it.

  1. D003695E01
    Using a press, press in the differential drive pinion.

    NOTICE:
    Press in the counter driven gear while rotating it.


3. INSTALL CYLINDRICAL ROLLER BEARING INNER RACE

D003696E01
  1. Using a press, press in the cylindrical roller bearing race inner.

    NOTICE:
    Press in the counter driven gear while rotating it.


4. INSTALL UNDERDRIVE INPUT SHAFT NUT

D025609E04
  1. Clamp the underdrive planetary gear in a soft jaw vise.

    NOTICE:
    Be careful not to damage the differential drive pinion.

  1. Using a socket wrench, install a new lock nut.

    Torque:
    280 N*m{ 2,855 kgf*cm , 207 in.*lbf }

    HINT:
    Use a torque wrench with a fulcrum length of 750 mm (29.53 in.)


5. INSPECT UNDERDRIVE PLANETARY GEAR PRELOAD

D025594E01
  1. Using SST and a torque wrench, measure the turning torque of underdrive planetary gear assembly while rotating the torque wrench at 60 rpm.

    SST
    09387-00050  

    Torque:
    Turning torque at 60 rpm:
    0.10 to 4.41 N*m{ 1.0 to 45 kgf*cm , 0.9 to 39 in.*lbf }

    HINT:
    Use a torque wrench with a fulcrum length of 160 mm (6.30 in.)

  1. C056809E01
    Using a pin punch and a hammer, stake the lock nut.

    NOTICE:
    Make sure that there are no cracks on the nut.

← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →