2005-2008 RAV4 · Service Manual STEERING

TERMINALS OF ECU

System information · Vehicles built from Nov 2005


CHECK STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU)
B128043E01
  1. Disconnect the E6 steering lock actuator connector.

  2. Measure the voltage and resistance of the wire harness side connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified condition
    GND (E6-1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    SGND (E6-2) - Body ground
    BR - Body ground
    Signal ground
    Always
    Below 1 Ω
    IG2 (E6-6) - GND (E6-1)
    B - W-B
    IG signal input
    Engine switch on (IG)
    10 to 14 V
    B (E6-7) - GND (E6-1)
    L - W-B
    Power source
    Always
    10 to 14 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the E6 steering lock actuator connector.

  4. Measure the voltage of the connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified condition
    IGE (E6-3) - GND (E6-1)
    Y - W-B
    Power source for motor drive
    Motor in operation
    Below 1 V
    Motor not in operation
    10 to 12 V
    SLP1 (E6-4) - SGND (E6-2)
    G - BR
    Unlock position sensor output signal
    Steering locked
    10 to 14 V
    Steering lock released
    Below 1 V
    LIN (E6-5) - SGND (E6-2)
    V - BR
    LIN communication bus
    Engine switch on (IG)
    Pulse generation
    If the result is not as specified, there may be a malfunction on the wire harness side.

← PROBLEM SYMPTOMS TABLE (from Aug 2007)DIAGNOSIS SYSTEM (from Nov 2005) →