2005-2008 RAV4 · Service Manual STEERING

Power Source Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit supplies power source voltage from the battery to terminal B of the steering lock actuator assembly.
The diagnosis information of the steering lock ECU is transmitted to the tester via the certification ECU as the steering lock ECU is not connected to the CAN communication system.

WIRING DIAGRAM

C117907E09

INSPECTION PROCEDURE

HINT:
When the engine switch is off, the main body ECU may occasionally go into a non-active state called sleep mode. Therefore, before proceeding with the inspection, it is necessary to perform the following step to wake up the ECU:
Before starting the inspection, with the engine switch off, open the driver door. Then (with the engine switch still off) open and close any door several times at 1.5 second intervals.


1. CHECK WIRE HARNESS (STEERING LOCK ACTUATOR - BODY GROUND)
C122327E16
  1. Disconnect the E6 steering lock actuator connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E6-1 (GND) - Body ground
    Below 1 Ω
    E6-2 (SGND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2. CHECK WIRE HARNESS (BATTERY - STEERING LOCK ACTUATOR)
C122327E17
  1. Disconnect the E6 steering lock actuator connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    E6-7 (B) - E6-1 (GND)
    10 to 14 V
    E6-7 (B) - E6-2 (SGND)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE STEERING LOCK ACTUATOR ASSEMBLY


← Unable to Lock Steering Wheel (from Nov 2005)COMPONENTS (from Nov 2005) →