B2797 Communication Malfunction No. 1
Diagnostic trouble codes · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
DESCRIPTION
This DTC is output when a communication error occurs between the transponder key amplifier and transponder key ECU. Some possible reasons for the communication error are: 1) 2 or more ignition keys are positioned too close together, or 2) noise is occurring in the communication line.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2797 |
Keys are positioned too close to each other, or noise occurred in communication line |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK KEY |
![]() ![]() |
Check if the ignition key being used is near other ignition keys. Also, check if the key ring is in contact with the key grip.
Result: Result
Proceed to
Key is near other keys and/or key ring is in contact with key grip
A
Key is not near other keys and/or key ring is not in contact with key grip
B
|
|
||||
| A | |
| 2. CHECK FOR DTC |
Separate the keys from each other and/or remove the key ring.
Clear the DTC (Click here).
Insert a key into the ignition key cylinder. Remove it. Repeat for all other keys.
Check that no DTC is output.
- OK:
- No DTC is output.
|
|
||||
| NG | |
| 3. CHECK TRANSPONDER KEY ECU (NOISE) |
![]() ![]() |
Using an oscilloscope or the intelligent tester, check for noise in the waveform between the terminals of the E8 amplifier connector and E50 ECU connector.
- OK:
- No noise is present (see illustration).
Tester Connection
Tool Setting
Tool Setting
Specified Condition
E50-15 (CODE) - E8-4 (CODE)
5 V/DIV., 20 msec./DIV.
Key inserted
No noise is present
|
|
||||
| OK | |
| 4. CHECK WIRE HARNESS (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER) |
![]() ![]() |
Disconnect the E50 ECU connector.
Disconnect the E8 amplifier connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E50-15 (CODE) - E8-4 (CODE)
Below 1 Ω
E50-15 (CODE) or E8-4 (CODE) - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 5. CHECK TRANSPONDER KEY AMPLIFIER (OPERATION) |
Temporarily replace the transponder key amplifier with a new or normally functioning one.
Check that the engine starts normally.
- OK:
- Engine starts normally.
|
|
||||
| OK | ||
| ||



