2005-2008 RAV4 · Service Manual SECURITIES

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


ENGINE IMMOBILISER SYSTEM DESCRIPTION
The engine immobiliser system is designed to prevent the vehicle from being stolen. This system uses a transponder key ECU that stores the key codes of authorized ignition keys. If an attempt is made to start the engine using an unauthorized key, the ECU sends a signal to the ECM to prohibit fuel delivery and ignition, effectively disabling the engine.

FUNCTION OF MAIN COMPONENT
Component
Outline
Transponder key coil/amplifier
When key is inserted into ignition key cylinder, key coil receives key code. Then amplifier amplifies ID code and outputs it to transponder key ECU
Unlock warning switch
Detects whether key is in ignition key cylinder and outputs results to transponder key ECU
ECM
Through SFI communication*1 (ECD communication*2) , ECM receives ID verification results from transponder key ECU. ECM also verifies ECUs. Then ECM judges whether or not to immobilize engine.
Security indicator light
Depending on operation of transponder key ECU, interior security indicator light comes on or starts blinking.

HINT:
*1: for 1AZ-FE, 2AZ-FE
*2: for 2AD-FTV


SYSTEM FUNCTION
  1. When the transponder key ECU detects that the unlock warning switch is ON, the ECU provides current to the transponder key coil and produces a faint electric wave. A transponder chip in the key grip receives the wave and outputs a key ID code signal. The transponder key coil receives this signal, the transponder key amplifier amplifies it, and then the signal is transmitted to the ECU. The ECU matches the key's ID code with the vehicle's ID code, which was previously registered in the ECU and then communicates the results to the ECM using SFI communication*1 (ECD communication*2).

    HINT:
    *1: for 1AZ-FE, 2AZ-FE
    *2: for 2AD-FTV

  2. After the identification results show that the key's ID code matches the vehicle's ID code and the ECU has confirmed their match: 1) the engine immobiliser system is canceled and the engine starting controls (fuel injection control and ignition control) enter standby mode; and 2) the ECU receives a security indicator light signal, and turns the security indicator light off.
← SYSTEM DIAGRAM (from Aug 2007)SYSTEM DESCRIPTION (Jan 2007 – Jul 2007) →