DATA LIST / ACTIVE TEST
System information · Vehicles built from Nov 2005
| READ DATA LIST |
- HINT:
- Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Engine immobiliser / Data List.
Check the results by referring to the table below.
Transponder key ECU: Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
IG SW
Ignition switch signal / ON or OFF
ON: Ignition switch on (IG or ACC)
OFF: Ignition switch off
-
Key SW
Unlock warning switch signal / ON or OFF
ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder
-
+B
+B judgment / NORMAL or BREAK
NORMAL: Battery supply is normal
BREAK: Battery supply is malfunctioning
-
Antenna Coil Status
Transponder key coil condition / NORMAL or FAIL
NORMAL: Transponder key coil is normal
FAIL: Transponder key coil is malfunctioning
-
Permit (Start)
Engine starting control / OK or NG
OK: Engine start is permitted
NG: Engine start is not permitted
-
Immobiliser
Immobiliser system status / SET or UNSET
UNSET: Key is in ignition key cylinder
SET: No key is in ignition key cylinder
-
Master Key
Master key code signal / Unreg or Reg
Unreg: Unmatched master key code is sent
Reg: Registered master key code is sent
-
Sub Key
Sub-key code signal / Unreg or Reg
Unreg: Unmatched sub-key code is sent
Reg: Registered sub-key code is sent
-
BCC Malfunction
Transponder chip signal / NG or OK
NG: Incorrect data sent
OK: Correct data sent
-
Abnormal Function
Transponder chip data / NG or OK
NG: Data error
OK: Data OK
-
Different Encrypt Code
Transponder chip data / NG or OK
NG: Data error
OK: Data OK
-
Different Serial Number
Transponder chip data / NG or OK
NG: Data error
OK: Data OK
-
Frame Error
Transponder chip data / NG or OK
NG: Data error
OK: Data OK
-
Response
Transponder chip data / NG or OK
NG: Data error
OK: Data OK
-
Reg Code Space Full
Key registration code memory space full / No or Yes
No: Possible to register more key codes
Yes: Cannot register any more key codes
-
Transponda M-Code
Number of registered master keys / min.: 0, max.: 15
Number of registered master keys
-
Transponda S-Code
Number of registered sub-keys / min.: 0, max.: 15
Number of registered sub-keys
-
| PERFORM ACTIVE TEST |
- HINT:
- Performing the intelligent tester's Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Engine immobiliser / Active Test.
Perform the Active Test by referring to the table below.
Transponder key ECU: Item
Test Details
Diagnostic Note
Security Indic
Turn security indicator light / ON or OFF
-