TERMINALS OF ECU
System information · Vehicles built from Nov 2005
| CHECK THEFT WARNING ECU |


Disconnect the E83 ECU connector.
Check the resistance and voltage of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
E (E83-16) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
+B1 (E83-11) - Body ground
R - Body ground
Battery
Always
10 to 14 V
IG (E83-9) - E (E83-16)
L - W-B
Ignition switch signal
Ignition switch off
Below 1 V
Ignition switch on (IG)
10 to 14 V
Reconnect the E83 ECU connector.
Check the voltages of the connector.
Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
BRK+ (E83-24) - Body ground
W - Body ground
Alarm BERKES Communication
Theft deterrent system is in alarm sounding state
Pulse generation
(1.5 V ← → Below 1.2 V)
BRK- (E83-25) - Body ground
B - Body ground
Alarm BERKES Communication
All doors are locked using key (theft deterrent system is in arming preparation state)
Pulse generation
(1.5 V ← → Below 1.2 V)
+B1 (E83-11) - E (E83-16)
R - W-B
+B power supply
Always
10 to 14 V
KSW*1 (E83-7) - E (E83-16)
L - W-B
Key unlock warning switch input
Key inserted
Below 1 V
No key is in ignition key cylinder
10 to 14 V
CTLS (E83-28) - Body ground
R - W-B
Theft warning siren signal
Theft warning siren is sounding (theft warning system is in alarm sounding state)
Pulse generation
IND (E83-29) - E (E83-16)
Y - W-B
Security indicator light
Security indicator lights up (illuminates for 30 seconds in alarm sounding state and flashes when immobiliser system is operating)
5 V or more
DSWH (E83-4) - E (E83-16)
R - W-B
Engine hood courtesy switch input
Engine hood is closed
10 to 14 V
Engine hood is open
Below 1 V
S+B (E83-21) - E (E83-16)
LG - W-B
Intrusion sensor power supply
Theft deterrent system is in alarm preparation state or armed state
10 to 14 V
Theft deterrent system is in disarmed state
Below 1 V
IOUT (E83-8) - E (E83-16)
O - W-B
Intrusion sensor signal input
No moving object detected
10 to 14 V
Moving object is detected during arming preparation state or armed state
Pulse generation
HORN (E83-31) - E (E83-16)
LG - W-B
Both vehicle horn signals output (low pitched and high pitched)
Armed state
10 to 14 V
- HINT:
- *: w/o Entry and start system