2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Wireless Door Lock Buzzer Does not Sound

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

Each of the entry and start system warnings use the wireless door lock buzzer to alert the driver. The certification ECU determines whether the wireless door lock buzzer must sound in accordance with the warning conditions.

WIRING DIAGRAM

B133429E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (WIRELESS DOOR LOCK BUZZER)
  1. Select the Active Test, use the intelligent tester to generate a control command, and then check that the wireless door lock buzzer sounds.

    Certification ECU: 
    Item
    Test Details
    Diagnostic Note
    Buzzer Resp Sound
    Wireless door lock buzzer ON / OFF
    -

    OK:
    Wireless door lock buzzer sounds.



OK
REPLACE ECU AGGREGATION BOX (CERTIFICATION ECU)
NG


2. CHECK WIRE HARNESS (CERTIFICATION ECU - WIRELESS DOOR LOCK BUZZER AND BODY GROUND)
B128001E02
  1. Disconnect the E63 ECU connector.

  1. Disconnect the A13 buzzer connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    BZR (E63-21) - A13-1
    Below 1 Ω
    A13-2 - Body ground
    BZR (E63-21) or A13-1 - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3. INSPECT WIRELESS DOOR LOCK BUZZER
B128002E02
  1. Remove the wireless door lock buzzer.

  1. Measure the resistance of the buzzer.

    HINT:
    The buzzer circuit is built into the ECU, not the buzzer itself. When battery voltage is applied directly to the buzzer, the buzzer will not sound.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 - 2
    Approx. 1 kΩ



NG
REPLACE WIRELESS DOOR LOCK BUZZER
OK

REPLACE ECU AGGREGATION BOX (CERTIFICATION ECU)


← DATA LIST / ACTIVE TEST (from Nov 2005)All Door Entry Lock and Unlock Functions do not Operate (from Nov 2005) →