2005-2008 RAV4 · Service Manual BODY

TERMINALS OF ECU

System information · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008


CHECK SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
B050671E75
  1. Disconnect the R9 ECU connector.

  2. Measure the resistance and voltage of the wire harness side connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    B (R9-1) - E (R9-2)
    L - W-B
    +B power supply
    Always
    10 to 14 V
    IG (R9-5) - E (R9-2)
    L - W-B
    Power supply
    Ignition switch off
    Below 1 V
    IG (R9-5) - E (R9-2)
    L - W-B
    Power supply
    Ignition switch on (IG)
    10 to 14 V
    DWN (R9-7) - E (R9-2)
    GR - W-B
    Sliding roof motor open
    SLIDE OPEN switch OFF
    10 kΩ or higher
    DWN (R9-7) - E (R9-2)
    GR - W-B
    Sliding roof motor open
    SLIDE OPEN switch ON
    Below 1 Ω
    UP (R9-9) - E (R9-2)
    G - W-B
    Sliding roof motor close
    TILT UP switch OFF
    10 kΩ or higher
    UP (R9-9) - E (R9-2)
    G - W-B
    Sliding roof motor close
    TILT UP switch ON
    Below 1 Ω
    E (R9-2) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

  3. Reconnect the R9 ECU connector.

  4. Measure the voltage of the connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    DWN (R9-7) - E (R9-2)
    GR - W-B
    Sliding roof motor open
    Ignition switch on (IG), sliding roof closed, SLIDE OPEN switch OFF
    Below 1 V
    DWN (R9-7) - E (R9-2)
    GR - W-B
    Sliding roof motor open
    Ignition switch on (IG), sliding roof closed, SLIDE OPEN switch ON
    10 to 14 V
    UP (R9-9) - E (R9-2)
    G - W-B
    Sliding roof motor closed
    Ignition switch on (IG), sliding roof open, TILT UP switch OFF
    Below 1 V
    UP (R9-9) - E (R9-2)
    G - W-B
    Sliding roof motor closed
    Ignition switch on (IG), sliding roof open, TILT UP switch ON
    10 to 14 V
    1. If the result is not as specified, the ECU may have a malfunction.

← TERMINALS OF ECU (Nov 2005 – Jul 2008)DIAGNOSIS SYSTEM (from Nov 2005) →