2005-2008 RAV4 · Service Manual BODY

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built from Nov 2005


GENERAL
This system has the following functions: manual slide open and close; auto slide open and close; manual tilt up and down; auto tilt up and down; jam protection.

FUNCTION OF MAIN COMPONENT
Component
Outline
Sliding roof drive gear sub-assembly (Sliding roof ECU)
Sliding roof ECU controls sliding roof motor to rotate forward and backward, which tilts or slides sliding roof glass.
Overhead junction block (Main body ECU)
Output of operation signals from built-in sliding roof switch to sliding roof ECU are handled by overhead junction block.

SYSTEM OPERATION
The sliding roof has the following features.
Function
Outline
Manual slide open and close
This function causes sliding roof to open (or close) when SLIDE OPEN switch (or TILT UP switch) is pressed for a maximum of 0.3 seconds. Sliding roof stops as soon as switch is released.
Auto slide open and close
This function causes sliding roof to be fully opened (or closed) when SLIDE OPEN switch (or TILT UP switch) is pressed for a minimum of 0.3 seconds.
Manual tilt up and down
This function causes sliding roof to tilt up (or tilt down) when TILT UP switch (or SLIDE OPEN switch) is pressed for a maximum of 0.3 seconds.
Auto tilt up and down
This function enables sliding roof to tilt up (or down) when TILT UP switch (or SLIDE OPEN switch) is pressed for a minimum of 0.3 seconds.
Jam protection function
The jam protection function automatically stops sliding roof, or stops sliding roof and makes it open halfway (or fully tilts it upward) if a foreign object gets jammed in sliding roof during auto close operation (or auto tilt down operation).
Key off operation
Key off operation function makes it possible to operate sliding roof for approximately 45 seconds after ignition switch off if front doors are not opened.

MULTIPLEX COMMUNICATION SYSTEM (LIN) FUNCTION DESCRIPTION
LIN communication is used to control the ECUs connected to the main body ECU. If the communication line becomes unusable, the main body ECU outputs the related diagnostic codes, and the fail-safe function is used for maintaining minimum performance and preventing the malfunction from affecting the system.
← SYSTEM DIAGRAM (from Nov 2005)HOW TO PROCEED WITH TROUBLESHOOTING (Nov 2005 – Jul 2008) →