2005-2008 RAV4 · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from Nov 2005


CHECK HEADLIGHT CLEANER CONTROL RELAY
E126459E01
  1. Disconnect the A44 relay connector.

  2. Measure the voltage and resistance of the wire harness side connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    IG (A44-3) - Body ground
    L - Body ground
    IG signal circuit
    Ignition switch on (IG)
    10 to 14 V
    Ignition switch off
    Below 1 V
    E (A44-4) - Body ground
    W-B - body ground
    Body ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the A44 relay connector.

  4. Measure the voltage of the connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    HDLO (A44-1) - Body ground
    BR - Body ground
    Headlight LO signal
    Headlight control switch LO
    10 to 14 V
    Headlight control switch except LO
    Below 1 V
    H (A44-2) - Body ground
    R - Body ground
    Headlight cleaner switch signal
    Headlight cleaner switch ON,
    headlight control switch LO
    10 to 14 V
    Headlight cleaner switch ON,
    headlight control switch except LO
    Below 1 V
    PB (A44-6) - Body ground
    B - Body ground
    Headlight cleaner motor signal
    Headlight cleaner switch ON,
    headlight control switch except LO
    10 to 14 V
    Headlight cleaner switch ON,
    headlight control switch LO
    Below 1 V
    If the result is not as specified, the headlight cleaner control relay may be malfunctioning.

← PROBLEM SYMPTOMS TABLE (from Nov 2005)COMPONENTS (from Nov 2005) →